1. This forum is obsolete and read-only. Feel free to contact us at support.keenswh.com

Mirror a blueprint or from the clip board?

Discussion in 'General' started by Alex Mauch, Jun 15, 2020.

Thread Status:
This last post in this thread was made more than 31 days old.
  1. Alex Mauch

    Alex Mauch Trainee Engineer

    Messages:
    1
    Hi All,

    Is it possible to mirror a blueprint or from the clipboard. I noticed on the steam forums SE Toolbox has a mirror function. However that no longer works with the current version of SE and the developer has left the SE community and stopped working on the mod.

    Is there another method?
     
  2. mojomann71

    mojomann71 Senior Engineer

    Messages:
    2,005
    SEToolbox has been picked up and is doing just fine.

    Not sure about the mirroring part of it if it is working since someone new took over.

    Here is the link to the new site for SET:
    https://github.com/mmusu3/SEToolbox/releases
     
  3. BitsNoKibbles

    BitsNoKibbles Apprentice Engineer

    Messages:
    110
    Mirroring works just fine in SEToolbox -- just remember to set your mirror axis.

    Nota bene: I've only used a single axis for mirroring, but it's always worked as expected. With multiple axes set, YMMV.
     
Thread Status:
This last post in this thread was made more than 31 days old.